Running Express Setup - Cisco Catalyst 2360 Getting Started Manual
Hide thumbs
Also See for Catalyst 2360:
- Hardware installation manual (74 pages) ,
- Software configuration manual (554 pages)
Table of Contents
Advertisement
Running Express Setup
When you first set up the switch, you should use Express Setup to enter the initial IP information. Doing
this enables the switch to connect to local routers and the network. You can then access the switch
through the IP address for further configuration.
You need this equipment to set up the switch:
•
•
Other laptops and browsers might work.
Note
•
Before running Express Setup, disable any pop-up blockers or proxy settings in your browser software
Note
and any wireless client running on your PC.
Step 1
Make sure that nothing is connected to the switch.
Step 2
During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address, temporarily
configure your PC settings to use DHCP before proceeding to the next step.
Note
OL-22149-02
A PC with Windows 2000, XP, Vista, or Windows Server 2003 installed
A web browser (Internet Explorer 6.0, 7.0, Firefox 1.5, 2.0, or later) with JavaScript enabled
A straight-through or crossover Category 5 or 6 Ethernet cable to connect your PC to the switch
Write down the static IP address. You need this IP address in
Running Express Setup
SYST
1X
PS1
PS2
FAN
STAT
11X 13X
DPLX
SPED
22X 25X
35X 37X
Cata lyst
2360
47X
Series
Step
10.
Catalyst 2360 Switch Getting Started Guide
3
Advertisement
Table of Contents
