Table of Contents
Advertisement
User Configurable Prefix/Suffix
One or two prefix or suffix characters can be added and assigned for
data transmission. Use one of the codes below with a 3 code byte
sequence that represents the desired character (see
Conversion
Chart, end of document) for your prefix or suffix. (To add
additional prefix/suffix characters, refer to your Single-Line
Configuration Guide.)
Scan the Enter/Exit Programming bar code to begin. Then scan
the 3 digit decimal equivalent of the ASCII character into the
appropriate character location with the code byte bar codes (see
Code
Bytes, end of document). To save, scan the Enter/Exit
Programming bar code again.
Example: To add an asterisk (*) as a prefix, scan the bar codes:
1. Enter/Exit Programming
2. Configurable Prefix #1
3. Code Byte 0
4. Code Byte 4
5. Code Byte 2
6. Enter/Exit Programming
³
9
9
9
Enter/Exit Programming
³
9
0
3
Configurable Prefix #2
³
9
0
4
Configurable Suffix #2
9
9
9
6
0
0
6
0
0
ASCII
³
9
0
3
5
Configurable Prefix #1
³
9
0
4
5
Configurable Suffix #1
0
0
0
0
Advertisement
Table of Contents
