Check Tftp Settings; Check Dhcp Settings; Verify Dns Settings - Cisco 7941G Troubleshooting And Maintenance
Hide thumbs
Also See for 7941G:
- Administration manual (302 pages) ,
- User manual (132 pages) ,
- Phone manual (92 pages)
Table of Contents
Advertisement
Check TFTP Settings
Check TFTP Settings
Procedure
Step 1
You can determine the IP address of the TFTP server used by the phone by pressing Settings, choosing
Network Configuration > IPv4 and scrolling to the TFTP Server 1 option.
Step 2
If you have assigned a static IP address to the phone, you must manually enter a setting for the TFTP Server
1 option. See
Step 3
If you are using DHCP, the phone obtains the address for the TFTP server from the DHCP server. Check the
IP address configured in Option 150.
Step 4
You can also enable the phone to use an alternate TFTP server. Such a setting is particularly useful if the
phone was recently moved from one location to another. See
Check DHCP Settings
Procedure
Step 1
On the Cisco Unified IP Phone, choose Settings > Network Configuration > IPv4 Configuration, and look
at the following options:
• DHCP Server: If you have assigned a static IP address to the phone, you do not need to enter a value for
• IP Address, Subnet Mask, Default Router: If you have assigned a static IP address to the phone, you
Step 2
If you are using DHCP, check the IP addresses distributed by your DHCP server. See the Understanding and
Troubleshooting DHCP in Catalyst Switch or Enterprise Networks document, available at this URL:
http://www.cisco.com/en/US/tech/tk648/tk361/tech_tech_notes_list.html
Verify DNS Settings
To verify DNS settings, perform these steps.
Procedure
Step 1
Verify this setting by pressing Settings.
Step 2
Choose Network Configuration and scroll to the DNS Server 1 option.
Step 3
Verify that a CNAME entry exists in the DNS server for the TFTP server and for the
Cisco Unified Communications Manager system.
Troubleshooting and Maintenance
14
Network Configuration
the DHCP Server option. However, if you are using a DHCP server, this option must have a value. If it
does not, check your IP routing and VLAN configuration. See the Troubleshooting Switch Port and
Interface Problems document, available at this URL :
http://www.cisco.com/en/US/products/hw/switches/ps708/prod_tech_notes_list.html
must manually enter settings for these options. See
Menu.
Network Configuration Menu
Network Configuration Menu
Troubleshooting and Maintenance
for instructions.
for instructions.
Advertisement
Table of Contents
Troubleshooting
