Table of Contents
Advertisement
As with chassis information, if you answer
prompted to re-enter all the trunk port information, beginning with the "
."
Type
If you answer
, you will be queried if you want to configure an additional trunk, as shown
Y
below:
Configure additional trunk port information (Y/N)? [N] Y
If you respond
to this query, repeat this procedure to configure additional trunk ports.
Y
If you respond
to this query, the system responds with the following message:
N
Creating minimum configuration database...done.
A trunk configuration CLI script has been written to /tmp/trunkconfig.cli
The message means that the system has created a minimum LS2020 configuration. It also
signifies that the system is loading the line cards, starting the LS2020 platform software,
and starting the neighborhood discovery process.
At this point, the login prompt appears. You can then continue with Step 7.
If you have previously configured trunk port information as part of the basic configuration
Step 7
procedure, you must apply that information to the platform software.
To apply trunk port information to the platform software, you must first wait for the line cards
Note
(which incorporate the trunk ports you need to configure) to come up. A line card is signaled as being
up when the
trap for that card appears on the console, as shown in the example below.
NDD_3
(OPER) NDD_3 at 03/05/96 10:56:04 EDT (03/05/96 14:54:04 GMT)
Line Card ls2020:5 (MS-TR) up.
Next, log in to the system and start the CLI using the
in the example below:
user name: npadmin
password: <password> Return
When you log into the
presenting the CLI banner on the console and then the CLI prompt, as shown in the example
below:
cli: (ls_main) compiled Mar 05 1996 @ 03:45:21
Copyright 1996. Cisco Systems, Inc. All Rights Reserved.
cli>
When the CLI prompt appears, enter the CLI protected mode, as shown below:
cli> protected
Enter Password: <password> Return
*cli>
Next, invoke the CLI configuration trunk script using the
below:
*cli> source "/tmp/trunkconfig.cli"
This command applies the trunk configuration to the trunk ports you have configured. Note
that additional traps may be generated at this time to signal the changes in the status of the
trunk ports. Such trap messages are normal.
to the port confirmation prompt, you will be
N
or
account, the CLI starts automatically, first
oper
npadmin
Basic LS2020 Configuration Tasks
Trunk Card
or
account, as shown
oper
npadmin
command, as shown
source
Hardware Installation 2-29
Advertisement
Table of Contents
