Emc Environmental Conditions For Products Installed In The European Union; Emc Class A Statements/Warnings - Cisco CISCO7301 Regulatory Compliance And Safety Information Manual

Internet router

Hide thumbs Also See for CISCO7301:

Configuration manual (308 pages)

Table Of Contents

Table of Contents

The Cisco 7301 meets the industry EMC, safety, and environmental standards described in

Table 2

Specification

NEBS

ETSI

1. NEBS = Network Equipment Building System

2. ETSI = European Telecommunication Standards Institute

EMC Environmental Conditions for Products Installed in the

European Union

This section applies to products to be installed in the European Union.

The equipment is intended to operate under the following environmental conditions with respect to

EMC:

•

In addition, if equipment is operated in a domestic environment, interference may occur.

EMC Class A Statements/Warnings

This section includes the EMC Class A warnings for the Cisco 7301 router.

FCC Class A

Modifying the equipment without Cisco's authorization may result in the equipment no longer

complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use

the equipment may be limited by FCC regulations, and you may be required to correct any interference

to radio or television communications at your own expense.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case users will be required to correct the

interference at their own expense.

78-16178-04

Industry EMC, Safety, and Environmental Standards

A separate defined location under user's control.

Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.

AC power distribution shall be one of the following types, where applicable: TN-S and TN-C as

defined in IEC 364-3.

Regulatory Compliance and Safety Information for the Cisco 7301 Internet Router