Table of Contents
Advertisement
Port Adapter Locations on the Supported Platforms
Figure 1-2
The PA-FE can be installed in the following slots on the hardware platforms described in this
document:
•
VIP2—Port adapter slot 0 and port adapter slot 1
•
Cisco 7200 series routers—Port adapter slot 1 and slot 2 of the Cisco 7202; port adapter slot 1
through slot 4 of the Cisco 7204 and Cisco 7204VXR; port adapter slot 1 through slot 6 of the
Cisco 7206 and Cisco 7206VXR
•
Cisco uBR7200 series universal broadband routers—Port adapter slot 1 and slot 2 of the
Cisco uBR7246; port adapter slot 1 of the Cisco uBR7223
•
Cisco 7100 series—Port adapter slot 3
Note
view of detail on the port adapter's faceplate.
Port Adapter Locations on the Supported Platforms
Figure 1-3 and Figure 1-4 show VIP2 models with installed port adapters. With the VIP2 oriented
as shown in Figure 1-3 or Figure 1-4, the left port adapter is in port adapter slot 0, and the right port
adapter is in port adapter slot 1.
In the Cisco 7000, Cisco 7507, and Cisco 7513 chassis, the VIP2 is installed vertically. In the
Cisco 7010 and Cisco 7505 chassis, the VIP2 is installed horizontally.
Figure 1-3
SRAM
DIMM U5
1-2
PA-FE-TX and PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
PA-FE-FX Port Adapter—Faceplate View
Port adapters have a handle attached, but this handle is occasionally not shown to allow a full
VIP2-15 or VIP2-40 with Two Port Adapters Installed—Horizontal Orientation
Bus connector
Port adapter
in slot 0
CPU
Boot ROM
U6
U2
U4
FAST ETHERNET
DRAM
SIMMs
Port adapter
in slot 1
Advertisement
Table of Contents
