Table of Contents
Advertisement
cisco 7200 (R4700) processor with 22528K/10240K bytes of memory.
R4700 processor, Implementation 33, Revision 1.0 (Level 2 Cache)
Last reset from power-on
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Chassis Interface.
4 Ethernet/IEEE 802.3 interfaces.
2 FastEthernet/IEEE 802.3 interfaces.
125K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2
Use the show diag slot command to determine which type of port adapter is installed in your system.
Specific port adapter information is displayed, as shown in the following example of a PA-FE-FX in
port adapter slot 2:
Router# show diag 2
Slot 2:
Fast-ethernet port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time 2d09h ago
Hardware revision 255.255 Board revision A0
Serial number
4294967295
Test history
0x0
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 02 01 01 FF FF FF FF 49 06 14 04 00 00 00 00
0x30: 50 00 00 00 FF FF FF FF FF FF FF FF FF FF FF FF
Proceed to the "Using the ping Command" section on page 8-13 to verify that each interface port is
functioning properly.
Part number
73-1556-04
RMA number
00-00-00
Configuring PA-FE Port Adapter Interfaces 8-11
Advertisement
Table of Contents
