Using an External Power Supply
The following warnings apply when you use the external power supply with the Cisco Unified IP Video
Phone 7985G:
Warning
This product relies on the building's installation for short-circuit (over current)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC,
10A international) is used on the phase conductors (all current-carrying conductors).
Warning
The device is designed to work with TN power systems.
Warning
The plug-socket combination must be accessible at all times because it serves as the
main disconnecting device.
Only use the Cisco specified power supply with this product.
Caution
Using External Devices with Your Cisco Unified IP Video Phone
The following information applies when you use external devices with the Cisco Unified IP Video
Phone:
Cisco recommends the use of good quality external devices (such as headsets) that are screened against
unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices such as mobile phones
or two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take
one or more of the following actions:
• Move the external device away from the source of the RF or AF signals.
• Route the external device cables away from the source of the RF or AF signals.
• Use screened cables for the external device, or use cables with a better screen and connector.
• Shorten the length of the external device cable.
• Apply ferrites or other such devices on the cables for the external device.
Cisco cannot guarantee the performance of the system because Cisco has no control over the quality
of external devices, cables, and connectors. The system will perform adequately when suitable devices
are attached by using good quality cables and connectors.
In European Union countries, use only external headsets that are fully compliant with the
Caution
EMC Directive [89/336/EC].
4
78-16798-02