Table of Contents
Advertisement
Wireless-G Portable USB Adapter
Appendix G: Regulatory Information
FCC STATEMENT
This (Series and Product name) has been tested and complies with the specifications for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used according to the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or device
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditons:
(1) The device may not cause harmful interference, and (2) thise device must accept any interference
received, including interference that may cause undesired operation.
Canada (IC) :
To prevent radio interference to the licensed service, this device is intended to be operated indoors and
away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed
outdoors is subject to licensing.
This device was tested for typical bystander conditions that may occur during use. To
comply with FCC RF exposure requirements, a minimum separation distance
of 1.5 cm must be maintained between the user's body and the device, including the
antenna.
Appendix G: Regulatory Information
Important: Cisco-Linksys, LLC declares
that WUSB54GP ver.4 (FCC ID: Q87-WU54GPV4
is limited in CH1~CH11 for 2.4 GHz by specified
firmware controlled in U.S.A.
Important:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment.
This device complies with FCC RF Exposure limits set
forth for an uncontrolled environments,
under 47 CFR 2.1093 paragraph (d)(2).
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
38
Advertisement
Table of Contents
