Table of Contents
Advertisement
Configuring the management interface (Transparent mode)
In Transparent mode, you can configure the management interface for management access to the DFL-500
NPG.
•
Go to System > Network > Management .
•
Change the Management IP and Mask as required.
These must be valid addresses for the network from which you will manage the DFL-500 NPG.
•
Select the management Access methods for each interface.
By default in Transparent mode, you manage the DFL-500 NPG by connecting to the internal
interface. However, you can configure the management interface so that you can manage the DFL-
500 NPG by connecting to any interface.
•
Select Apply to save your changes.
Setting DNS server addresses
Several DFL-500 NPG functions, including sending email alerts and URL blocking, use DNS.
•
Go to System > Network > DNS .
•
Change the primary and secondary DNS server addresses as required.
•
Select Apply to save your changes.
Configuring routing
You can configure routing to add static routes from the DFL-500 NPG to local routers. You can also use
routing to add multiple routing gateways. This section describes:
•
Adding routing gateways
•
Adding a default route
•
Adding routes to the routing table
•
Configuring the routing table
•
Enabling RIP server support
•
Adding routes (Transparent mode)
Adding routing gateways
The first step in configuring DFL-500 NPG routing is to add routing gateways. Routing gateways are the
gateways on your network that you want to route DFL-500 NPG traffic to. You can add the IP address of each
routing gateway, and you can also optionally configure the DFL-500 NPG to ping the routing gateway at a
specified time interval to make sure that the DFL-500 NPG can communicate with the routing gateway.
To add a routing gateway:
•
Go to System > Network > Routing Gateway .
•
Select New to add a new routing gateway.
•
Enter the IP address of the routing gateway.
This IP address should be on the same subnet as the DFL-500 NPG interface that connects to this
gateway.
•
Select Dead gateway detection if you want the DFL-500 NPG to confirm connectivity with the
gateway.
DFL-500 User Manual
92
Advertisement
Table of Contents
