Table of Contents
Advertisement
DFL-500 NPG network connections
Configuring your internal network
If you are running the DFL-500 NPG in NAT/Route mode, your internal network must be configured to route
all internet traffic to the address of the internal interface of the DFL-500 NPG. This means changing the
default gateway address of all computers connected directly to the internal network.
If you are using the DFL-500 NPG as the DHCP server for your internal network, configure the computers on
your internal network for DHCP.
When the DFL-500 NPG is connected, make sure that it is functioning properly by connecting to the Internet
from a computer on your internal network. You should be able to connect to any Internet address.
Completing the configuration
Use the information in this section to complete the initial configuration of the DFL-500 NPG.
Setting the date and time
For effective scheduling and logging, the DFL-500 NPG date and time should be accurate. You can either
manually set the DFL-500 NPG time or you can configure the DFL-500 NPG to automatically keep its time
correct by synchronizing with a Network Time Protocol (NTP) server.
To set the DFL-500 NPG date and time, see
Setting system date and
time.
DFL-500 User Manual
18
Advertisement
Table of Contents
