Table of Contents
Advertisement
Configuring user groups
Use the following information to add user groups to your DFL-500 configuration. You can add user names and
RADIUS servers to user groups.
You can then add user groups to:
•
Policies that require authentication
policies). Only users in the selected user group or that can authenticate with the RADIUS servers
added to the user group can authenticate with these policies.
•
IPSec VPN Remote Gateways for dial-up users
user group can authenticate with this Remote Gateway.
•
The DFL-500 PPTP configuration
can use PPTP.
•
The DFL-500 L2TP configuration
can use L2TP.
If you add a user group to a policy or remote gateway, or to your PPTP or L2TP configuration, do not delete
the user group until you remove it from the policy, remote gateway, or configuration.
This section describes:
•
Adding user groups
•
Deleting user groups
Adding user groups
To add a user group:
•
Go to User > User Group.
•
Select New to add a new user group.
•
Enter a Group Name to identify the user group.
The name can contain numbers (0-9), uppercase and lowercase letters (A-Z, a-z), and the special
characters - and _. Other special characters and spaces are not allowed.
•
To add users to the user group, select a user from the Available Users list and select the right arrow
to add the name to the Members list.
•
To add a RADIUS server to the user group, select a RADIUS server from the Available Users list and
select the right arrow to add the RADIUS server to the Members list.
DFL-500 User Manual
(Adding NAT/Route mode
(Configuring dialup
(PPTP VPN
configuration). Only users in the selected user group
(L2TP VPN
configuration). Only users in the selected user group
policies, and
Adding NAT/Route mode
VPN). Only users in the selected
46
Advertisement
Table of Contents
