Page 1
Service Manual ORDER NO. CRT3021 RX330 AUDIO SYSTEM HEAD UNIT VEHICLE DESTINATION PRODUCED AFTER TOYOTA PART No. ID No. PIONEER MODEL No. LEXUS RX330 EUROPE February 2003 86120-48210 P3918 FX-MG8037ZT/EW 86120-48350 P3918 FX-MG8037ZT-91/EW 86120-48230 P3919 FX-MG8137ZT/EW 86120-48370 P3919 FX-MG8137ZT-91/EW Manufactured for TOYOTA...
Page 2
For details, refer to "Important symbols for good services". FX-MG8037ZT/EW(P3918) FX-MG8137ZT/EW(P3919) - This service manual should be used together with the following manual(s): Model No. Order No. Mech. Module Remarks CX-1011 CRT2406 Cassette Mech. Module:Mech.Description, Disassembly CX-951 CRT2872 CD Mech. Module:Circuit Description, Mech.Description, Disassembly - Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation.
3.3 OVERALL CONNECTION DIAGRAM(GUIDE PAGE) Note: When ordering service parts, be sure to refer to " EXPLODED VIEWS AND PARTS LIST" or "ELECTRICAL PARTS LIST". Large size SCH diagram FM/AM TUNER UNIT FM(30%,400Hz):-24.9dBs FX-MG8037ZT/EW FX-MG8137ZT/ AM(30%,400Hz):-11.8dBs ANTENNA C411 R022 MAIN UNIT...
Page 7
TUNER MIXING AMP UNBALANCE TO BALANCE SYSTEM MUTE AUDIO SELECTOR FM: -9.6dBs FOR AMP FX-MG8137ZT/EW AM:-11.5dBs TAPE: -7.5dBs CD: +2.3dBs FX-MG8037ZT/EW FX-MG8137ZT/EW UNBALANCE TO BALANCE SYSTEM MUTE AUDIO SELECTOR FOR RSA > FM: -3.9dBs AM: -5.8dBs TAPE: -1.9dBs CD:+8.0dBs...
LOAD2 LOADING MOTOR CAMGEAR MOTOR M1 CXC1144 PCB UNIT(LOAD) SIGNAL LINE FOCUS SERVO LINE TRACKING SERVO LINE CARRIAGE SERVO LINE SPINDLE SERVO LINE : The power supply is shown with the marked box. C D E F G H FX-MG8037ZT/EW...
SP Line AUI- AUI+ M/L AMP SYSTEM cannot use GGD1317. Because, external connector is different from pioneer AMP and M/L AMP(PIO:24P-20P,M/L:25P-16P). Moreover, GGD1240 which is a previous jig cannot be used (Because the signal array is different). Therefore, when the head unit of the M/L AMP system is repaired, pioneer AMP system is used.
Page 23
SP Line (To DC Regulated Power Supply) M/L AMP SYSTEM cannot use GGD1317. Because, external connector is different from pioneer AMP and M/L AMP(PIO:24P-20P,M/L:25P-16P). Moreover, GGD1240 which is a previous jig cannot be used (Because the signal array is different).
Page 24
Extention Cord GGD1121 DECK UNIT Pin2 VR301 VR302 VR561 IC601 CN251 Pin3 L-CH R-CH Meter(1) DOLBY B NR ADJUSTMENT Test Tape Adjustment Point Adjustment Method (Switch Position) NCT-150 VR301(Lch),VR302(Rch) mV Meter(1) : –8.24dBm(300mV)±1dB (400Hz,200nwb/m) (DOLBY NR Switch : OFF) FX-MG8037ZT/EW...
Page 26
7.3.1 SYSTEM BLOCK DIAGRAM - System 1 +B, ACC SPEAKER Except FL AMPLIFIER NAVI GM-8337ZT/E or OTHER MAKERS FL(or FR) OTHER MAKERS FX-MG8037ZT/EW AVC-LAN OTHER MAKERS FX-MG8137ZT/EW - System 2 +B, ACC SPEAKER AMPLIFIER GM-8337ZT/E or OTHER MAKERS FX-MG8037ZT/EW FX-MG8137ZT/EW...
After disconnecting the power supply connector and removing this product, confirm that you can see a metal plate through the hole near the "SHIP" mark on the rear chassis. Confirm that the door of the CD player is closed. FX-MG8037ZT/EW...