Table of Contents
Advertisement
b. Lubricate the O-ring "3" of the new oil filter
cartridge with a thin coat of lithium-soap-
based grease.
ECA13390
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter car-
tridge.
c. Tighten the new oil filter cartridge to speci-
fication with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Install:
• Engine oil drain bolt
(along with the gasket
Engine oil drain bolt
43 Nm (4.3 m·kgf, 31 ft·lbf)
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
8. Install:
• Dipstick
(along with the O-ring
New
)
)
New
3-26
PERIODIC MAINTENANCE
Engine oil quantity
Total amount
4.30 L (4.55 US qt, 3.78 Imp.qt)
Without
replacement
3.70 L (3.91 US qt, 3.26 Imp.qt)
With oil filter cartridge replace-
ment
4.00 L (4.23 US qt, 3.52 Imp.qt)
9. Start the engine, warm it up for several
minutes, and then turn it off.
10. Check:
• Engine
(for engine oil leaks)
11. Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-24.
12. Remove:
• Side cover (cylinder head)
Refer to "GENERAL CHASSIS" on page
4-1.
• Rear cylinder right plastic cover
• Rear cylinder right plastic cover bracket
Refer to "ENGINE REMOVAL" on page 5-
1.
• Fuel tank bracket bolts
Refer to "FUEL TANK" on page 6-1.
13. Check:
• Engine oil pressure
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Slightly loosen the front cylinder oil check
bolt "1" and rear cylinder oil check bolt "2".
TIP
To loosen the rear cylinder oil check bolt "2", lift
up the back of the fuel tank first.
oil
filter
cartridge
Advertisement
Table of Contents
Troubleshooting
