Table of Contents
Advertisement
• Infrastructure (wireless relay): Only choose this setting if
• Vehicle: Choose this setting if the unit is installed on or in
4.
If the Unit Role has been set as Vehicle, assign the unit a
vehicle identity using either of the methods below:
• Allow the unit to automatically generate a unique vehicle
• Assign a vehicle identity manually by un-checking
5.
The network type must be set in accordance with the general
network architecture. Select the correct network type designation
for the unit by clicking the Network Type: drop-down and clicking
the correct option from the list below:
• Flat: Choose this setting if the wireless mesh network and
• Multiple Subnets: Choose this setting if the wireless mesh
6.
Save the Fluidity settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
the unit is used as a wireless relay agent to other
infrastructure units.
IMPORTANT
If a unit is set to Infrastructure (wireless
relay) mode, do not connect the unit to the
wired LAN.
a moving vehicle.
identity by checking the Enable check-box to the right of
the Automatic Vehicle ID: heading.
the Enable check-box to the right of the Automatic
Vehicle ID: heading, and manually entering an
identification string in the Vehicle ID: field.
IMPORTANT
If vehicle identities have been
manually assigned, the Vehicle ID string must
be unique for every individual Fluidmesh unit
operating on the same network, even if more
than one Fluidmesh unit is installed on the
same vehicle.
the infrastructure network both belong to a single layer-2
broadcast domain.
network and the infrastructure network are organized as
separate layer-3 routing domains.
Page 119 of 177
Advertisement
Table of Contents
