Table of Contents
Advertisement
Connecting to a Console Port (Optional)
2. Install or remove the card:
a. To install a card, slide it into the slot, and press it in until it clicks in place. The card is keyed so that
b. To remove the card, push it in until it releases for it to pop out. Place it in an antistatic bag to protect
3. After the card is installed, close the guard door and fasten the captive screw using a Phillips screwdriver
to keep the door in place.
Connecting to a Console Port (Optional)
You can also enter CLI commands through the console port. For more information about this process see
Accessing the CLI Through the Console
Attaching an Expansion Module (Optional)
If you're installation calls for use of one of the expansion modules listed in Switch Models, use the following
procedure to attach the module to the switch:
Danger
Do not attach any expansion module to a switch while the switch is energized.
1. Remove the 2 screws securing the side cover plate to the switch.
2. Remove the two screws from the front of the Expansion chassis, and the two screws from the rear of the
base.
Switch Installation
6
you cannot insert it the wrong way.
it from static discharge.
Port.
Switch Installation
Hide quick links:
Advertisement
Table of Contents
