Installing The Shelf Bracket Kit Into A Four-Post Eia Rack - Cisco MDS 9100 Series Hardware Installation Manual

Hide thumbs Also See for MDS 9100 Series:

Table of Contents

Chapter 1

Cabinet and Rack Installation

Installing the Shelf Bracket Kit into a Four-Post EIA Rack

Figure 1-2

1 Rack-mounting rail (4x)

2 Shelf bracket (2x)

3 Slider rail (2)

To install the shelf brackets in an EIA rack, follow these steps:

Step 1

Position a shelf bracket inside the rack-mounting rails as shown in

the front of the shelf bracket with the holes in the front rack-mounting rail. Then attach the shelf bracket

to the front rack-mounting rail using a minimum of four 12-24 or 10-24 screws.

Note

Step 2

Repeat with the other shelf bracket.

Step 3

Verify that the shelf brackets are at the same height (using the level or tape measure as desired).

OL-20185-01

shows the installation of the shelf bracket kit into a four-post EIA rack.

Installing the Shelf Bracket Kit into an EIA Rack

The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the

rack-mounting rail (the hole immediately above the 1/2-in. spacing).

Cisco MDS 9000 Family Telco and EIA Shelf Bracket

4 Crossbar

5 10-32 screws (2x)

Cisco MDS 9148S Multilayer Switch Hardware Installation Guide

Figure

1-2. Align the screw holes at

1-49

Table of Contents

Mds 9148s Ds-c9148s48pk9