Table of Contents
Advertisement
7
Connecting with the Discharge
Tube
Parts needed for this procedure:
1
Discharge tube
Procedure
1. Slide the curved end of the discharge tube into the
opening in the bagger top
2
1
3
4
Figure 29
1. Discharge tube
2. Opening in bagger top
3. Discharge tube, flared end
2. Slide the flared end of the discharge tube over the
end of the chute. Move the rubber retaining strap on
the chute snaps over the peg on the discharge tube to
secure it
(Figure
29).
3. After the bagger installation, install the wire onto the
spark plug(s).
(Figure
29).
G010641
5
4. Peg
5. Rubber strap
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
WARNING
To avoid personal injury, follow these procedures:
• Become familiar with all operating and safety
instructions in the Operator's Manual for the
mower before using this attachment.
• Never remove the discharge tube, bags, bagger
top, or the chute while the engine is running.
• Always shut the engine off and wait for all
moving parts to stop before clearing an
obstruction from the bagging system.
• Never do maintenance or repairs while the
engine is running.
Emptying the Grass Bags
Be careful when lifting or handling a grass bag that is full. To
empty the grass bags:
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, set the
parking brake and wait for all moving parts to stop
before leaving the operating position.
3. Open (raise) the bagger top
4. Compress debris into the bags. With both hands, lift up
on the bag and unhook it from the retaining bracket.
Empty the bag. Repeat the procedure for the other bag.
5. Install the bags by sliding the bag frame hooks onto the
retaining brackets
15
(Figure
30).
G005758
Figure 30
(Figure
31).
- Quick Links:
- Installing the Chute
Hide quick links:
Advertisement
Table of Contents
