Meaning Of The Leds On The Terminal Module Tm150 - Siemens SINAMICS DCM Operating Instructions Manual
Control module
Hide thumbs
Also See for SINAMICS DCM:
- List manual (1205 pages) ,
- Manual (705 pages) ,
- Operating instructions manual (554 pages)
Table of Contents
Advertisement
7.6.5
Meaning of the LEDs on the Terminal Module TM150
Table 7- 49
Meaning of the LEDs at the Terminal Module TM150
LED
Color
–
Green
Orange
READY
Red
Green/
Red
Green/
orange
or
red/
orange
Cause and rectification of faults
The following documents contain information about the cause of faults and how they can be
rectified:
SINAMICS S120 Commissioning Manual with STARTER
SINAMICS DCM List Manual
SINAMICS DCM Control Module
Operating Instructions, 12/2018, A5E34888669A
State
Description, cause
Off
Electronic power supply is missing or outside permissible
tolerance range.
Continuous
The component is ready for operation and cyclic DRIVE-
light
CLiQ communication is taking place.
Continuous
DRIVE-CLiQ communication is being established.
light
At least one fault is present in this component.
Continuous
Remark:
light
LED is controlled irrespective of the corresponding
messages being reconfigured.
Flashing
Firmware is being downloaded.
light
0.5 Hz
Flashing
Firmware has been downloaded.
light
Wait for POWER ON.
2 Hz
Component recognition via LED is activated (p0154).
Flashing
Remark:
light
Both options depend on the LED status when module
2 Hz
recognition is activated via p0154 = 1.
Additional system components
7.6 Terminal Module TM150
Remedy
Check power supply
–
–
Remedy and
acknowledge fault
–
Carry out a
POWER ON
–
229
Advertisement
Table of Contents
