hit counter script
Sharp QT-CD131H Operation Manual
  1. Manuals
  2. Brands
  3. Sharp Manuals
  4. Stereo System
  5. QT-CD131H
  6. Operation manual

Sharp QT-CD131H Operation Manual

Portable cd stereo system
Hide thumbs Also See for QT-CD131H:
Table of Contents

Advertisement

Quick Links

Download this manual
YT
PORTABLE CD STEREO SYSTEM
Thank you for purchasing this SHARP product.
For the best performance, read this manual care-
fully. It will guide you in operating your SHARP
product.
The mains lead of this product is fitted with a non-rewire-
able (moulded) plug incorporating a 3A fuse. Should the
fuse need to be replaced, a BSI or ASTA approved BS
1362 fuse marked
above, which is also indicated on the pin face of the plug
must be used.
Always refit the fuse cover after replacing the fuse. Never
use the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home
not being compatible with the plug supplied, cut-off the
mains plug and fit an appropriate type.
DANGER:
The fuse from the cut-off plug should be removed and
the cut-off plug destroyed immediately and disposed of
in a safe manner.
Under no circumstances should the cut-off plug be in-
serted elsewhere into a 13A socket outlet as a serious
electric shock may occur.
To fit an appropriate plug to the mains lead, follow the
instructions below:
IMPORTANT:
The wires in the mains lead are coloured in accordance
with the following code:
Blue
Brown
As the colours of the wires in the mains lead of this
product may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
● The wire which is coloured blue must be connected to
● The wire which is coloured brown must be connected
Downloaded from:
http://www.usersmanualguide.com/
<P=001>
NOTE FOR USERS IN THE U.K.
or
and of the same rating as
: Neutral
: Live
the plug terminal which is marked N or coloured black.
to the plug terminal which is marked L or coloured red.
QT-CD131H(SUK) TINSE0007SJZZ
MODEL
QT-CD131H
OPERATION MANUAL
Ensure that neither the brown nor the blue wire is con-
nected to the earth terminal in your three pin plug.
Before replacing the plug cover, make sure that:
● If the new fitted plug contains a fuse, its value is the
same as that removed from the cut-off plug.
● The cord grip is clamped over the sheath of the mains
lead and not simply over the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED
ELECTRICIAN.
SERVICE INFORMATION
In the unlikely event of your equipment requiring repair,
please contact the dealer or supplier from whom it was
purchased. Where this is not possible, please contact
the telephone number listed below. You will then be
given details of how to obtain service.
Please note; all calls will be charged at local rate.
Certain replacement parts and accessories may be ob-
tained from our main parts distributor.
WILLOW VALE ELECTRONICS LTD.
MANCHESTER 0161-682-1415
READING
In the unlikely event of this equipment requiring repair
during the guarantee period, you will need to provide
proof of the date of purchase to the repairing company.
Please keep your invoice or receipt, which is supplied at
the time of purchase.
- 0345-125387 -
01189-876444

Advertisement

Table of Contents
loading

Related Manuals for Sharp QT-CD131H

Summary of Contents for Sharp QT-CD131H

  • Page 1 OPERATION MANUAL Thank you for purchasing this SHARP product. For the best performance, read this manual care- fully. It will guide you in operating your SHARP product. NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewire- Ensure that neither the brown nor the blue wire is con- able (moulded) plug incorporating a 3A fuse.

  • Page 2: Special Notes

    ● Recording and playback of any material may Caution: require consent, which SHARP is unable to give. ● Use of controls, adjustments or performance of Please refer particularly to the provisions of the procedures other than those specified herein Copyright Act 1956, the Dramatic and Musical may result in hazardous radiation exposure.
  • Page 3 ● Do not write on either side of the disc, particularly damage. SHARP will not be held responsible for any the non-label side. Signals are read from the damage resulting from use of this unit with a voltage non-label side.

  • Page 4: Battery Power

    STAND-BY, ON PRESET BAND MEMORY TUNING DOWN DOWN VOLUME X-BASS REVIEW/ STOP PLAY DOWN REPEAT Sound control After use: FUNCTION ● X-BASS ● Volume TUNER TAPE VOLUME STAND-BY X-BASS Set the FUNCTION switch to STAND-BY. QT-CD131H(SUK) TINSE0007SJZZ Downloaded from: http://www.usersmanualguide.com/...
  • Page 5 STOP button play to stop CD operation. ● If the beginning of the track is reached whilst reviewing, the mode will automatically switch to normal playback at that point. QT-CD131H(SUK) TINSE0007SJZZ Downloaded from: http://www.usersmanualguide.com/...

  • Page 6: Radio Operation

    ● 10 AM stations can be preset (preset channels 1 through 10). (There are no presets 11 through 20 for AM stations.) ● If the "MEMORY" and preset number indicators go out before the station is memorised, repeat the operation from step 2. QT-CD131H(SUK) TINSE0007SJZZ Downloaded from: http://www.usersmanualguide.com/...
  • Page 7 AC power. ● If the memory batteries are not inserted and the power is disconnected, the tuner’s preset memories will be erased. ● Replace the memory batteries approximately once a year. QT-CD131H(SUK) TINSE0007SJZZ Downloaded from: http://www.usersmanualguide.com/...

  • Page 8: Tape Playback

    STOP/EJECT button. Headphones ● Be sure your headphones have a 3.5 mm (1/8") diameter plug and are be- tween 16 ohms and 50 To PHONES ohms impedance. The recommended impedance is 32 ohms. QT-CD131H(SUK) TINSE0007SJZZ Downloaded from: http://www.usersmanualguide.com/...
  • Page 9 ● Tune in to the station to be recorded. To erase a recorded tape: 1 Set the FUNCTION switch to TAPE. 2 Load the tape to be erased into the cassette compartment. 3 Press the RECORD button. QT-CD131H(SUK) TINSE0007SJZZ Downloaded from: http://www.usersmanualguide.com/...

  • Page 10: Specifications

    AM; 522 - 1,620 kHz TERMS OF GUARANTEE Sharp Electronics (UK) Ltd. ("Sharp") guarantees to provide for the repair, or at its option the replacement, of this product subject to the conditions listed below:- This guarantee shall only apply to faults which are due to inferior workmanship or materials.
  • Page 11 This file has been downloaded from: www.UsersManualGuide.com User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes.. Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide, manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product, documentation manual, user maintenance, brochure, user reference, pdf manual Downloaded from:...

Table of Contents