Enabling Dhcp; Disabling Dhcp; Configuring Static Settings - Cisco 7920 Administration Manual
Wireless ip phone
Hide thumbs
Also See for 7920:
- Administration manual (238 pages) ,
- User manual (144 pages) ,
- Phone manual (98 pages)
Table of Contents
Advertisement
Verifying or Entering Network Settings
Enabling DHCP
Step 1
Step 2
Step 3
Step 4
Disabling DHCP
Note
Step 1
Step 2
Step 3
Step 4
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
5-8
Chapter 5
The Cisco IP Phones enable DHCP by default, but you can reset the protocol if it
becomes disabled. Use the following steps to enable DHCP from the phone.
Procedure
Press the Menu softkey.
Choose Network Config > DHCP Enable/Disable.
Scroll to Enable and press Select.
A check mark appears next to the selected option.
Press Back to exit the menu and save the change.
Related Topics
•
Disabling DHCP, page 5-8
Configuring Static Settings, page 5-9
•
If you do not use DHCP in your network, use this procedure to disable DHCP
before manually assigning IP addresses to Cisco IP Phones.
When DHCP is enabled in your network, you cannot complete procedures to
configure IP settings or TFTP options.
Procedure
Press the Menu softkey.
Choose Network Config > DHCP Enable/Disable.
Scroll to Disable and press Select.
The Disable menu options display.
Scroll to Activate and press Select.
Configuring Network Settings on the Cisco Wireless IP Phone 7920
OL-3930-02
Advertisement
Table of Contents
Troubleshooting
