Removing And Replacing The Hard Drive On The Cisco Asr 1002-X Router - Cisco ASR 1000 Series Replacing

Removing and replacing frus from the routers

Hide thumbs Also See for ASR 1000 Series:

Software configuration manual (602 pages)

Configuration manual (442 pages)

Common criteria operational user guidance and preparative procedures (72 pages)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

page of 120

/ 120
Contents
Table of Contents
Bookmarks

Table of Contents

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Removing and Replacing the Hard Drive on the Cisco ASR 1002-X

Router

The Cisco ASR 1002-X Router supports an optional removable hard drive. This section explains how to

remove and replace this hard drive.

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch

the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

Before you begin, read the following important notices:

• The hard drive is accessible from the front panel of the router and supports the online insertion and

• The reason you may be removing an internal hard drive is that it is failing or failed; so any data recovery

• If the drive is functioning, you can back it up to a drive plugged into a USB port using the archive tar

Removing the Hard Drive from the Cisco ASR 1002-X Router

To remove the hard drive from the Cisco ASR 1002-X Router, follow this procedure:

SUMMARY STEPS

1. Run the request platform hardware filesystem harddisk: offline command.

2. Slip on an ESD-preventive wrist strap.

3. From the front panel of the router, unscrew the fastener screws by using a # 2 Phillips screwdriver or a

flat head screwdriver (see xref Figure 14-6).

4. Pull the hard drive out as shown in xref Figure 14-7.

5. Place the hard drive in an antistatic bag if you are returning it.

6. Wait until the following console message is displayed:

DETAILED STEPS

Step 1

Run the request platform hardware filesystem harddisk: offline command.

Step 2

Slip on an ESD-preventive wrist strap.

Step 3

From the front panel of the router, unscrew the fastener screws by using a # 2 Phillips screwdriver or a flat head screwdriver

(see xref Figure 14-6).

removal feature (OIR) using the following CLI commands:

• request platform hardware filesystem harddisk: offline (unmounts the hard disk)

• request platform hardware filesystem harddisk: online (mounts the hard disk.)

may be lost.

command.