Cisco NCS 1004 Command Reference Manual page 63
Hide thumbs
Also See for NCS 1004:
- Hardware installation manual (70 pages) ,
- Manual (52 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
Commands
pm
To configure the performance monitoring parameters of the optics, Ethernet, and coherent DSP controllers,
use the pm command in the controller configuration mode.
pm [15-min | 30-sec | 24-hour] [optics | ether | pcs | fec | otn] [report | threshold] value
Syntax Description
15-min | 30-sec | 24-hour
optics | ether | pcs | fec |
otn
report
threshold
value
None
Command Default
Controller configuration
Command Modes
Command History
Release
Release
7.0.1
The following table describes the optics PM parameters.
Usage Guidelines
Parameter
cd
dgd
lbc
lbc-pc
low-freq-off
opr
opt
osnr
pcr
pdl
Configures performance monitoring parameters for 15 minute or 30
second or 24 hour intervals.
Specifies whether to configure performance monitoring parameters for
the optics, Ethernet, or coherent DSP controllers.
Configures optics TCA reporting status.
Configures threshold on optics parameters.
Value of the reporting or threshold parameters.
Modification
This command was introduced.
Description
Chromatic dispersion TCA reporting status or threshold
Differential group delay TCA reporting status or threshold
lbc TCA reporting status or threshold
lbc percentage TCA reporting status or threshold
low signal frequency offset TCA reporting status or threshold
opr/opr-dbm TCA reporting status or threshold
opt/opt-dbm TCA reporting status or threshold
Optical Signal to Noise Ratio TCA reporting status or threshold
Polarization Change Rate TCA reporting status or threshold
Polarization Dependent Loss TCA reporting status or threshold
Command Reference for Cisco NCS 1004
pm
57
- Quick Links:
- Controller Optics
Hide quick links:
Advertisement
Table of Contents
