Hw-Module - Cisco NCS 1004 Command Reference Manual
Hide thumbs
Also See for NCS 1004:
- Hardware installation manual (70 pages) ,
- Manual (52 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
hw-module
hw-module
To configure the card in the module (muxponder), slice configuration (muxponder slice), or regen mode, use
the hw-module command in IOS XR configuration mode.
hw-module location
[100GE | OTU4] trunk bitrate [150G | 200G | 250G | 300G | 350G | 400G | 450G | 500G | 550G | 600G]
[drop-lldp]
hw-module location
hw-module location location mxponder arp-snoop
Syntax Description
location location
mxponder
mxponder-slice mxponder-slice-number
client bitrate [100GE | OTU4]
trunk bitrate [150G | 200G | 250G | 300G | 350G | 400G | 450G |
500G | 550G | 600G]
drop-lldp
client-port-ains-soak hours hours minutes minutes
regen trunk-rate trunk-rate
arp-snoop
Command Reference for Cisco NCS 1004
30
location { mxponder | mxponder-slice mxponder-slice-number } client bitrate
[client-port-ains-soak hours hours
location { regen trunk-rate trunk-rate }
minutes
minutes ]
Specifies the location of the optics
controller.
Configures the card in muxponder
mode.
Configures the card in muxponder
slice configuration. Slice numbers
can be 0 or 1.
Specifies the traffic rate on the
client ports. The supported client
rates are 100GE and OTU4.
Specifies the traffic rate on the
trunk ports. The supported trunk
rates are 150G, 200G, 250G, 300G,
350G, 400G, 450G, 500G, 550G,
and 600G.
Note
Enables LLDP drop on a
muxponder or muxponder slice.
Specifies the AINS configuration
in hours and minutes.
Configures the card in Regen mode.
The supported trunk rates are 100G
to 600G in multiples of 100G.
Configures MAC address or ARP
snoop on the client ports.
Commands
The 150G, 250G, 350G,
450G, and 550G data
rates can be configured
only in the muxponder
card mode.
- Quick Links:
- Controller Optics
Hide quick links:
Advertisement
Table of Contents
