Cisco NCS 1004 Command Reference Manual page 18
Hide thumbs
Also See for NCS 1004:
- Hardware installation manual (70 pages) ,
- Manual (52 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
Commands
controller HundredGigECtrlr
Example
The following example shows how to configure the performance monitoring parameters of the
Ethernet controller in 15 minute intervals.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller HundredGigECtrlr 0/1/0/10 pm 15-min pcs report bip
enable
The following example shows how to configure the internal loopback.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller HundredGigECtrlr 0/1/0/10 secondary-admin-state
maintenance
RP/0/RP0/CPU0:ios(config)#controller HundredGigECtrlr 0/1/0/10 loopback internal
RP/0/RP0/CPU0:ios(config)#commit
The following example enables IDLE hold off timer in Ethernet controller.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller HundredGigECtrlr 0/1/0/10 holdoff-time trunk-fault
3000
RP/0/RP0/CPU0:ios(config)#commit
The following is a sample where laser quelching is enabled on the Ethernet controller.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller HundredGigECtrlr 0/1/0/10 laser-squelch
RP/0/RP0/CPU0:ios(config)#commit
Command Reference for Cisco NCS 1004
12
- Quick Links:
- Controller Optics
Hide quick links:
Advertisement
Table of Contents
