Installing A Controller Canister In The Controller-Drive Tray - Bosch DSA E Series Installation Manual
Iscsi disk arrays
Hide thumbs
Also See for DSA E Series:
- Installation manual (54 pages) ,
- Installaton manual (50 pages) ,
- Quick installation manual (30 pages)
Table of Contents
Advertisement
96
en | Replacing a Controller Canister in the Controller-Drive Tray
1
3
Figure 13.7 Battery and Thumbscrew in the Controller Canister
1
2
3
16. Remove the battery by sliding it towards the rear of the failed controller canister. You will
17. If Small Form-factor Pluggable (SFP) transceivers are present, record the ports in which
13.2
Installing a Controller Canister in the Controller-Drive Tray
1.
2.
NOTICE!
To ensure that the battery is seated correctly, you might need to back it out of the connector
to make sure that it is correctly aligned with the thumbscrew.
3.
4.
- | V2 | 2012.09
2
Top Cover Latch Buttons
Battery Circuit Board
Thumbscrew
insert this battery into the new controller canister.
they are installed, and remove them.
If SFP transceivers were present, reinstall them in the correct ports in the new controller.
Did the failed controller canister contain a battery?
–
Yes
Remove the top cover by sliding it off the rear of the new controller canister, and go
to step 3.
–
No
Go to step 6.
Insert the battery circuit board that you removed from the failed controller canister by
sliding it towards the front of the new controller canister.
Tighten the thumbscrew to secure the battery circuit board in the new controller canister
card.
Installation Manual
E2600 DSA E-Series iSCSI Disk Arrays
98015-03
Bosch Security Systems
Advertisement
Table of Contents
