Table of Contents
Advertisement
Cisco cBR-8 Converged Cable Access Router Supervisor 250G
Port
Console port
Note
The ports on the Supervisor Card are used for temporary connections. For all permanent connections, including
the console connection, you must use the ports on the Supervisor PIC installed in the rear of the chassis.
The Supervisor Card has the following LEDs:
LED
PWR STAT
RP STAT
RP ACT
FP STAT
FP ACT
INSI ACT
ALRM
RPLC
Important
Different Supervisor Cards cannot coexist on a Cisco cBR-8 router. We recommend that you install the
Supervisor Cards with the same capacity in the chassis to ensure proper redundancy support.
Supervisor PIC
The Supervisor PIC provides the physical interface to the Supervisor Card. It is installed in the rear of the
Cisco cBR chassis.
Cisco Converged Broadband Routers Hardware Installation Guide
22
What is a Cisco cBR Series Converged Broadband Router
Description
The Supervisor Card has one mini type-B USB
console port. This port is an asynchronous
EIA/TIA-232 serial port used to connect a terminal
to the Supervisor Card for local administrative access.
Description
Power status LED
RP status LED
RP active LED
FP status LED
FP active LED
iNSI active LED
Alarm LED
Replace LED
Advertisement
Table of Contents
Troubleshooting
