Table of Contents
Advertisement
Installing the Supervisor in the Cisco cBR Chassis
Figure 72: Closing the Ejector Levers on the Supervisor PIC
Step 6
Tighten the four captive screws using a 3/16" flat-blade torque screwdriver with a torque of 6-8 in-lb (0.68-0.90 Nm) to
secure the PIC.
What to do next
• If you are using a single Supervisor PIC,
•
•
Installing the Supervisor PIC Cable Management Bracket
The Supervisor PIC cable management bracket is shipped separately in the chassis accessory kit. It has a
smaller slot for fiber-optic cables and a larger slot for the RJ-45 cables.
Before you begin
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
•
Required Tools and Equipment
Install the Supervisor PIC cable management bracket
Install the Supervisor Card
(if not already installed).
connected to the chassis.
Install the Supervisor PIC
(recommended).
Installing the Supervisor PIC Cable Management Bracket
install a blank PIC for the Supervisor
(recommended).
Cisco Converged Broadband Routers Hardware Installation Guide
in the empty slot.
111
Advertisement
Table of Contents
Troubleshooting
