Table of Contents
Advertisement
Figure 17
1. Shoulder bolt
2. Idler pulley
15.
Install the belt onto the clutch. Verify that the
belt is still routed on the blower pulleys and is
seated properly in the pulley grooves.
Note:
You can use a drive ratchet (1/2 inch) to
move the left idler pulley for the blower
18).
Figure 18
1. Drive ratchet
16.
Raise the blower as described in
Blower (page
13).
17.
Connect the hydraulic hoses to the
quick-disconnect couplings on the Low Flow
Hydraulics Kit.
g293529
3. Belt
(Figure
g231579
2. Pulley
Raising the
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
Fluid injected into the skin must be
surgically removed within a few hours by
a doctor familiar with this form of injury;
otherwise, gangrene may result.
• Ensure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are
tight before applying pressure to the
hydraulic system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks; never use your
hands.
11
Advertisement
Table of Contents
