Table of Contents
Advertisement
Available languages
Available languages
ABOUT CERAMIC TECHNOLOGY
Ceramic heaters generate heat by passing electricity through heating wires embedded in ceramic plates.
This type of heating technology provides consistent, even heating.
The 360º Ceramic Surround Heater has an organic industrial design that maximizes heat output. It is
designed with fan power to improve convection in order to provide both all around or directional heating
comfort to you and your room.
For best result, place heater on the floor to create warming room convection and allow heater to run for
5-10 minutes to reach maximum heat output.
SET-UP
Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9 m) away from
any wall or combustible material.
DO NOT use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS.
MOVING THE HEATER
Turn off the heater.
Allow it to cool for ten minutes.
Unplug heater and move. This heater is equipped with a Cool Touch Handle for your convenience.
OPERATION
NOTE: The 360º Ceramic Surround Heater requires no assembly.
NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
With the Power Knob or Power Button (
position, plug the heater into a polarized 120V outlet.
DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET;
it will only fit one way.
The 360º Ceramic Surround Heater is versatile and designed for all
around heat output in 360° ( ) mode or directional heating when in
the 180° (
) mode.
To set 360° surround heating – on back of the heater, push the
directional lever in the UP position (Fig. 1)
To set 180° directional heating – on back of the heater, push the
directional lever in the DOWN position (Fig. 2)
) in the OFF (
)
Fig. 1
Fig. 2
3
Advertisement
Table of Contents
