Table of Contents
Advertisement
Chapter 4
Configuring the PA-VXA, PA-VXB, and PA-VXC
Table 4-1
Syntax of the shutdown Command
Platform
Cisco 7200 series and
Cisco 7200 VXR routers
Cisco 7301 routers
Cisco 7401ASR routers
VIP in Cisco 7500 series routers controller, followed by the type
Step 4
Write the new configuration to NVRAM as follows:
Router# copy running-config startup-config
[OK]
Router#
The system displays an OK message when the configuration has been stored in NVRAM.
Step 5
Verify that the new interface is now in the correct state (shut down) using the
show controllers command (followed by the interface type and interface address of the interface) to
display the specific interface.
Reenable the interface by doing the following:
Step 6
a.
b.
c.
For complete descriptions of software configuration commands, refer to the publications listed in the
"Related Documentation" section on page
OL-3592-02
Command
controller, followed by the type
(t1 or e1) and slot/port
(port-adapter-slot-number/
interface-port-number)
controller, followed by the type
(t1 or e1) and slot/port
(port-adapter-slot-number/
interface-port-number)
controller, followed by the type
(t1 or e1) and slot/port
(port-adapter-slot-number/
interface-port-number)
(t1 or e1) and slot/port
adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
Repeat Step 3 to reenable an interface. Substitute the no shutdown command for the shutdown
command.
Repeat Step 4 to write the new configuration to memory. Use the
copy running-config startup-config command.
Repeat Step 5 to verify that the interface is in the correct state. Use the show controllers command
followed by the type and address of the controller.
Example
The example is for the T1 controller in port adapter
slot 1.
Router(config)# controller t1 1/0
Router(config)# shutdown
Ctrl-Z
Router#
The example is for the T1 controller in port adapter
slot 1.
Router(config)# controller t1 1/0
Router(config)# shutdown
Ctrl-Z
Router#
The example is for the T1 controller in port adapter
slot 1.
Router(config)# controller t1 1/0
Router(config)# shutdown
Ctrl-Z
Router#
The example is for the T1 controller in port adapter
slot 0 of a VIP installed
in interface processor slot 1.
Router(config-if)# controller t1 1/0/0
Router(config-if)# shutdown
Ctrl-Z
Router#
viii.
T1/E1 Digital Voice Port Adapter Installation and Configuration
Configuring the Interface
4-3
Advertisement
Table of Contents
Troubleshooting
