Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-VXA, PA-VXB, and PA-VXC port adapters. This chapter contains the following sections:
•
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install a port adapter. If you need additional equipment, contact
a service representative for ordering information.
•
•
Note
•
•
•
•
OL-3592-02
Required Tools and Equipment, page 2-1
Software and Hardware Requirements, page 2-2
Checking Hardware and Software Compatibility, page 2-3
Safety Guidelines, page 2-3
FCC Class A Compliance, page 2-6
PA-VXA-1TE1-24+(=), PA-VXA-1TE1-30+(=), PA-VXB-2TE1(=), PA-VXB-2TE1+(=),
PA-VXC-2TE1(=), or PA-VXC-2TE1+(=) port adapter
Shielded cables (foil twisted-pair [FTP]) with 120-ohm impedance (for E1 connections only)
To comply with Conducted Susceptibility of the CE marking requirements, shielded
120-ohm (screened) cables should be used with this board.
Number 2 Phillips screwdriver
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares
Antistatic mat
Antistatic container
C H A P T E R
T1/E1 Digital Voice Port Adapter Installation and Configuration
2
2-1
Advertisement
Table of Contents
Troubleshooting
