Table of Contents
Advertisement
Chapter 4
Configuring the PA-VXA, PA-VXB, and PA-VXC
Table 4-4
Command
show interfaces type
port-adapter-slot-number/
interface-port-number
show protocols
show running-config
show startup-config
If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections and offers some platform-specific output examples:
•
•
•
Choose the subsection appropriate for your system. Proceed to the
on page 4-42
Using the show version or show hardware Commands
Use the show version (or show hardware) command to display the configuration of the system
hardware, the number of each interface type installed, the Cisco IOS software version, the names and
sources of configuration files, and the boot images.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Cisco 7200 Series and Cisco 7200 VXR Routers
Following is an example of the show version command from a Cisco 7206VXR router:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-IS-M), Version 12.0(5)XE3,
TAC:Home:SW:IOS:Specials for info
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Sat 20-Nov-99 10:51 by en
Image text-base: 0x60008900, data-base: 0x6139A000
OL-3592-02
Using show Commands (continued)
Using the show version or show hardware Commands, page 4-35
Using the show diag Command, page 4-37
Using the show interfaces Command, page 4-40
when you have finished using the show commands.
Function
Displays status information about a
specific type of interface (for
example, DSPfarm) in
Cisco 7200 series routers,
Cisco 7200 VXR routers,
Cisco 7401ASR routers, or
Cisco 7500 series routers
Displays protocols configured for the
entire system and for specific
interfaces
Displays the running configuration
file
Displays the configuration stored in
NVRAM
T1/E1 Digital Voice Port Adapter Installation and Configuration
Checking the Configuration
Example
Router# show interfaces
DSPfarm 1/0
Router# show protocols
Router# show
running-config
Router# show
startup-config
"Using loopback Commands" section
4-35
Advertisement
Table of Contents
Troubleshooting
