Configuring Port Group Monitor; Enabling A Port Group Monitor; Configuring A Port Group Monitor Policy - Cisco MDS 9000 Series Configuration Manual
Interface
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Configuring Port Group Monitor
• We recommend that you use the delta threshold type for all the counters except the tx-slowport-oper-delay
Note
counter which uses absolute threshold type.
• The rx-datarate and tx-datarate are calculated using the inoctets and outoctets on an interface.
• You must activate the err-pkt-from-port, err-pkt-from-xbar, and err-pkt-to-xbar counters using the
monitor counter name command, before specifying the counter parameters.
• Counters err-pkt-from-xbar, err-pkt-from-port, and err-pkt-to-xbar support delta threshold type only.
• Counter tx-slowport-oper-delay supports absolute threshold type only.
• Counter tx-slowport-oper-delay does not support portguard action.
• You must first enable ER_RDY flow-control mode using the system fc flow-control er_rdy command
and then enable congestion isolation using the feature congestion-isolation command before setting the
portguard action as congestion isolate (cong-isolate). For more information, see
Port-Monitor Portguard Action for Congestion Isolation, on page
• The cong-isolate port monitor portguard action is used only for configuring the credit-loss-reco,
tx-credit-not-available, tx-slowport-oper-delay, and txwait counters.
Configuring Port Group Monitor
Enabling a Port Group Monitor
To enable a port group monitor, perform these steps:
Step 1
Enter configuration mode:
switch# configure terminal
Step 2
Enable port monitoring:
switch(config)# port-group-monitor enable
(Optional) Disable port monitoring:
switch(config)# no port-group-monitor enable
Configuring a Port Group Monitor Policy
To configure a port group monitor policy, perform these steps:
Step 1
Enter configuration mode:
switch# configure terminal
Step 2
Specify the policy name and enter port group monitoring policy configuration mode:
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
56
Configuring Interfaces
Configuring the
180.
- Quick Links:
- E Port
- Configuring Isl between Two Switches
Hide quick links:
Advertisement
Table of Contents
