Configuring Portchannels; Configuring Portchannels Using The Wizard Creating A Portchannel; Configuring The Portchannel Mode; Deleting Portchannels - Cisco MDS 9000 Series Configuration Manual
Interface
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Configuring PortChannels
Configuring PortChannels
Configuring PortChannels Using the Wizard Creating a PortChannel
To create a PortChannel, perform these steps:
Step 1
switch# configure terminal
Enters configuration mode.
Step 2
switch(config)# interface port-channel 1
Configures the specified PortChannel (1) using the default ON mode.
Configuring the PortChannel Mode
By default, the CLI and the Device Manager create the PortChannel in ON mode in the NPIV core switches
and ACTIVE mode on the NPV switches. DCNM-SAN creates all PortChannels in ACTIVE mode. We
recommend that you create PortChannels in ACTIVE mode.
Note
An F PortChannel is supported only on ACTIVE mode.
To configure ACTIVE mode, perform these steps:
Step 1
switch# configure terminal
Enters configuration mode.
Step 2
switch(config)# interface port-channel 1
Configures the specified PortChannel (1) using the default ON mode.
Step 3
switch(config-if)# channel mode active
Configures the ACTIVE mode.
switch(config-if)# no channel mode active
(Optional) Reverts to the default ON mode.
Deleting PortChannels
To delete a PortChannel, perform these steps:
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
Configuring PortChannels
235
- Quick Links:
- E Port
- Configuring Isl between Two Switches
Hide quick links:
Advertisement
Table of Contents
