Connecting The Temperature Sensor/Anti-Condensation Heater - Siemens SIMOTICS SD Operating Instructions Manual
Low-voltage motors
Hide thumbs
Also See for SIMOTICS SD:
- Operating instructions manual (142 pages) ,
- Compact operating instructions (166 pages) ,
- Operating instructions manual (140 pages)
Table of Contents
Advertisement
Electrical connection
6.1 Connecting the machine
Damage to connecting cables that are freely led out
You must observe the following note to avoid damaging connecting cables that are freely
led out:
• It must be ensured that there are no foreign bodies, dirt, or moisture in the terminal base
• Use O-rings or suitable flat gaskets to seal entries in cover plates (DIN 42925) and other
• Seal the terminal base of the machine enclosure using the original seal of the cover
• Please observe the tightening torques for cable glands and other screws.
6.1.8.4
Connecting the temperature sensor/anti-condensation heater
Auxiliary circuits are connected in the terminal box.
Figure 6-1
Figure 6-2
48
CAUTION
of the machine enclosure.
open
entries.
plate to prevent dust and water from entering.
Connection to terminal strip
Connection to terminal board
Operating Instructions, 05/2014, 5 610 00000 02 000
Low-voltage motors
Advertisement
Table of Contents
