Chapter 3
Installing the Cisco CVA122/CVA122E Cable Voice Adapter
Figure 3-8
Ethernet 10BaseT
Step 3
Connect the other end of the cable to the Ethernet port on the PC or hub. Press the cable firmly into the
receptacle.
Step 4
Verify that the Ethernet LED on the front panel of the Cisco CVA122/CVA122E Cable Voice Adapter
turns on. If this LED does not light, check that the Ethernet cable is plugged in to the correct RJ-45
connector on your computer and that the computer is turned on. Also verify that the other end of the
cable is completely plugged into the Ethernet port on the cable voice adapter.
Connecting to the Computer (USB)
This section describes how to connect Cisco CVA122/CVA122E Cable Voice Adapter to a computer
using the Universal Serial Bus (USB) interface. (If you are not using the USB interface, complete the
"Connecting to the Computer (Ethernet)" section on page 3-14 before proceeding.)
Step 1
Verify that your computer is turned on and meets the requirements in Table 2-1 on page 2-4. In
particular, your computer must be running Windows 98, Windows 98 Second Edition, Windows 2000,
or Windows Millennium.
Note
If using a USB hub, verify that it is already installed and working before connecting the
Step 2
Cisco CVA122/CVA122E Cable Voice Adapter.
Plug the broad, flat plug (the type "A" or host end) of the USB cable into the USB port on your computer
Step 3
(or USB hub).
Plug the other rectangular box plug (the type "B" or device end) of the USB cable into the USB port on
Step 4
the rear panel of the Cisco CVA122/CVA122E Cable Voice Adapter. (See Figure 3-9.)
OL-0799-02 (05/2001)
Connecting the Ethernet Cable to the Cisco CVA122/CVA122E Cable Voice Adapter
E th e rn e t
P h o n e
X
U S B
V 1 + V 2
E t h e r n e t
(RJ45)
X
Computers running Windows 95 or Windows NT do not support USB networking
connectivity.
P o w e r
C a b le T V
+ 5 ,- 3 0 ,- 5
6
In
V
V 2
Ethernet cable
To computer
Cisco CVA122/CVA122E Hardware Installation Guide
Connecting to the Computer (USB)
3-15