Setting Spf Interval For A Single-Topology Ipv4 And Ipv6 Configuration - Cisco ASR 9000 Series Configuration Manual
Aggregation services router
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing IS-IS
Command or Action
Step 12
show isis [ instance instance-id ] interface [ type
interface-path-id ] [ brief | detail ] [ level { 1 | 2 }]
Example:
RP/0/RSP0/CPU0:router# show isis interface
GigabitEthernet 0/1/0/1 brief
Step 13
show isis [ instance instance-id ] neighbors [ interface-type
interface-instance ] [ summary ] [ detail ] [ systemid system-id
]
Example:
RP/0/RSP0/CPU0:router# show isis neighbors summary
Setting SPF Interval for a Single-Topology IPv4 and IPv6 Configuration
This task explains how to make adjustments to the SPF calculation to tune router performance. This task is
optional.
Because the SPF calculation computes routes for a particular topology, the tuning attributes are located in the
router address family configuration submode. SPF calculation computes routes for Level 1 and Level 2
separately.
When IPv4 and IPv6 address families are used in a single-topology mode, only a single SPF for the IPv4
topology exists. The IPv6 topology "borrows" the IPv4 topology; therefore, no SPF calculation is required for
IPv6. To tune the SPF calculation parameters for single-topology mode, configure the address-family ipv4
unicast command.
The incremental SPF algorithm can be enabled separately. When enabled, the incremental shortest path first
(ISPF) is not employed immediately. Instead, the full SPF algorithm is used to "seed" the state information
required for the ISPF to run. The startup delay prevents the ISPF from running for a specified interval after
an IS-IS restart (to permit the database to stabilize). After the startup delay elapses, the ISPF is principally
responsible for performing all of the SPF calculations. The reseed interval enables a periodic running of the
full SPF to ensure that the iSFP state remains synchronized.
OL-30423-03
Setting SPF Interval for a Single-Topology IPv4 and IPv6 Configuration
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
Purpose
(Optional) Displays information about the IS-IS
interface.
(Optional) Displays information about IS-IS neighbors.
309
Advertisement
Table of Contents
