Port Shaper Policy Support on L2 Fabric ICL Interface
• Pseudowire Headend (PW-HE) and Broadband Network Gateway (BNG) configurations are not supported
Configuring Port Shaper Policy on the ICL Interface in L2 Fabric Mode
Perform this task to apply the port shaper policy on the L2 fabric inter-chassis link (ICL) ethernet virtual
circuits (EVC). This procedure applies the port shaper in the egress direction of the ICL EVC.
Before You Begin
The nV satellite configuration must be applied on the inter-chassis link (ICL) interface.
SUMMARY STEPS
1. configure
2. policy-map [ type qos ] policy-name
3. class class-name
4. shape {shape [units] | average value}
5. exit
6. end-policy-map
7. interface type interface-path-id
8. service-policy output policy-map
9. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
policy-map [ type qos ] policy-name
Example:
RP/0/RSP0/CPU0:router(config)# policy-map icl_ps
Step 3
class class-name
Example:
RP/0/RSP0/CPU0:router(config-pmap)# class
class-default
Step 4
shape {shape [units] | average value}
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# shape average
400 mbps
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release
6.1.x
128
under the satellite interfaces in L2 fabric or simple ring mode.
Configuring Modular QoS Service Packet Classification
Purpose
Creates or modifies a policy map that can be attached
to one or more ICL interfaces to specify a service
policy and enters the policy map configuration mode.
Specifies the name of the class whose policy you
want to create or change.
Specifies the port shape allocated for a class
belonging to a policy map.