Table of Contents
Advertisement
2 . Press button "Dry only" to dry without a wash
cycle .
3 . Select the type of drying desired, by pressing
the "Dryness level" button for automatic
drying levels or the «Drying
set drying time .
- Automatic drying with selectable levels:
In automatic drying mode, the washer dryer
machine dries the laundry until the set
level of dryness is reached . Pressing button
"Dryness level" once automatically selects the
highest drying level available for the selected
programme . Press the button again to reduce
the drying level .
The following levels are available:
Wardrobe
: laundry is completely dry and
ready to be put away in the wardrobe without
ironing .
Hanger
: laundry is left slightly damp to
minimise creasing . Garments must be hung to
air dry completely .
Iron
: garments are left reasonably damp to
make ironing easier .
- Timer drying mode:
To set a specific drying time, press the "Drying
time" button until the led for the desired time is
illuminated . Values from 180 to 40 minutes are
settable
N .B .: always allow a cooling down period after
drying before opening the door .
5 . USING THE CORRECT AMOUNT OF
DETERGENT . Pull out the tray and pour
detergent into the relative compartments
as described in "Detergent dispenser" . This is only
necessary when using a wash only or a wash +
dry programme .
6 . DELAYING THE START OF A PROGRAMME . To
set a programme to start at a later time, see the
section "Programmes and Options" .
7 . STARTING A PROGRAMME .
Press the START/PAUSE button . The
corresponding indicator light is illuminated,
the door locks and the door open
extinguishes . To change a programme while
a cycle is in progress, press START/PAUSE to
pause the washer dryer (the START/ PAUSE
lamp flashes amber slowly); then select the
required cycle and press START/PAUSE again .
To open the door while a cycle is in progress,
press START/PAUSE; the door may be opened
if the
symbol lights . Press the START/PAUSE
button again to resume the programme from
where it was paused .
time»
button to
symbol
8 . CANCELLING A RUNNING PROGRAMME (IF
NECESSARY)
Press and hold the button
dryer stops .
If the water level and temperature are low
enough, the door unlocks and may be opened .
The door remains locked if there is water in
the drum . To unlock the door, switch the
washer dryer on and select the SPIN & DRAIN
programme . The water is emptied and the door
unlocks at the end of the programme .
9 . SWITCHING THE WASHER DRYER OFF AT THE
END OF A PROGRAMME .
At the end of the programme, the door open
light will switch on . The door can only be
opened when the
the door open light is on, then open the door
and remove the laundry .
Press
to switch the washer dryer off . To save
energy, if the washer dryer is not switched
off manually with the
automatically approximately 30 minutes after
the end of the programme .
Leave the door ajar to let the interior of the
washer dryer dry .
until the washer
symbol lights . Check that
button, it turns off
EN
15
Hide quick links:
Advertisement
Table of Contents
