Xconfiguration Network [1] Qos Diffserv Icmpv6; Xconfiguration Network [1] Qos Diffserv Ntp; Xconfiguration Network [1] Remoteaccess Allow - Cisco TelePresence SX80 Reference Manual
Application programming interface (api)
Hide thumbs
Also See for TelePresence SX80:
- Reference manual (231 pages) ,
- Administrator's manual (183 pages) ,
- Installation manual (24 pages)
Table of Contents
Advertisement
Cisco TelePresence SX80
Introduction
xConfiguration Network [1] QoS Diffserv ICMPv6
This setting will only take effect if Network QoS Mode is set to Diffserv.
Define which priority ICMPv6 packets should have in the IP network.
The priority for the packets ranges from 0 to 63 - the higher the number, the higher the priority.
The recommended value for ICMPv6 is 0, which means best effort. If in doubt, contact your
network administrator.
The priority set here might be overridden when packets are leaving the network controlled by
the local network administrator.
Requires user role: ADMIN, USER
Default value: 0
USAGE:
xConfiguration Network
n
QoS Diffserv ICMPv6:
where
: Index that identifies the network. Range: 1..1
n
: Integer (0..63)
ICMPv6
Set the priority of the ICMPv6 packets in the IP network - the higher the number, the
higher the priority. The default value is 0 (best effort).
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API
xConfiguration
xConfiguration
ICMPv6
xCommand
xConfiguration Network [1] QoS Diffserv NTP
This setting will only take effect if Network QoS Mode is set to Diffserv.
Define which priority NTP packets should have in the IP network.
The priority for the packets ranges from 0 to 63 - the higher the number, the higher the prior-
ity. The recommended value for NTP is 0, which means best effort. If in doubt, contact your
network administrator.
The priority set here might be overridden when packets are leaving the network controlled by
the local network administrator.
Requires user role: ADMIN, USER
Default value: 0
USAGE:
xConfiguration Network
n
QoS Diffserv NTP:
where
: Index that identifies the network. Range: 1..1
n
: Integer (0..63)
NTP
Set the priority of the NTP packets in the IP network - the higher the number, the higher
the priority. The default value is 0 (best effort).
xConfiguration Network [1] RemoteAccess Allow
Define which IP addresses (IPv4/IPv6) are allowed for remote access to the codec from SSH/
Telnet/HTTP/HTTPS. Multiple IP addresses are separated by a white space.
A network mask (IP range) is specified by <ip address>/N, where N is 1-32 for IPv4, and N is
1-128 for IPv6. The /N is a common indication of a network mask where the first N bits are set.
Thus 192.168.0.0/24 would match any address starting with 192.168.0, since these are the first
24 bits in the address.
Requires user role: ADMIN, USER
Default value: ""
USAGE:
xConfiguration Network
n
RemoteAccess Allow: "Allow"
where
: Index that identifies the network. Range: 1..1
n
: String (0, 255)
Allow
A valid IPv4 address or IPv6 address.
63
API Reference Guide
xStatus
Appendices
NTP
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
- Quick Links:
- Commands
- About Disconnect Cause Types
Hide quick links:
Advertisement
Chapters
Table of Contents
