Connect To Ac Power - Cisco 1120 Hardware Installation

Connected grid router

Hide thumbs Also See for 1120:

Table of Contents

Figure 4

Terminal Block Mating Connectors Connected to Router Chassis

Connect to AC Power

This section describes how to make two the following types of AC power connections to the router:



Single-phase AC



Three-phase AC

Note:

The AC power connection mating connector shipped with the router is a 5-way screw terminal printed circuit board

plug connector manufactured by Phoenix Contact (part number 1913604).

To connect the router to AC power, follow these steps:

Note:

The router will power on as soon as it is connected to an AC power source. You are not required to press a power

button to power on the router.

Caution:

When connecting the router AC power connector, always connect the router end of the cable first. When

removing the AC power connector, always disconnect the router end of the cable last.

Turn off power to the AC power source at the designated circuits.

Use a wire-stripping tool to strip each of the wires from the AC-input power source. Expose the wire to the

appropriate length for the terminal block, about 0.25 inches.

Insert the wires into the AC power connector terminals described in

Insert wires that correspond to your installation (three-phase or single-phase), as shown in

Figure 1 on page 48

and

Table 1 on page

48.

Figure 5 on page

52.

Table of Contents

Table of Contents