Table of Contents
Advertisement
Installing the Chassis
Figure 9: Cisco 8201 Router Ground Lug
1
Step 5
Tighten the pan-head screws to torque value of 11.5 in-lbs (1.3 N-m).
Step 6
Ensure that the lug and cable do not interfere with other equipment.
Step 7
Prepare the other end of the grounding cable, and connect it to an appropriate grounding point in your site to ensure
adequate earth ground.
Connect AC Power to the Chassis
Caution
The chassis relies on the protective devices in the building installation to protect against short circuit,
overcurrent, and ground faults. Ensure that the protective devices comply with local and national electrical
codes.
Note
Cisco 8201 Router—To provide full output power of 2000 W, the nominal voltage rating value ranges between
200V to 240V, depending on the standards in various countries.
The following combinations of power supplies are supported:
Grounding lug
Hardware Installation Guide for Cisco 8200 Series Routers
Connect AC Power to the Chassis
2
M4 x 6mm pan-head screws
21
Hide quick links:
Advertisement
Table of Contents
