Cisco 1120 Hardware Installation page 38

Connected grid router

Hide thumbs Also See for 1120:

Table of Contents

Use the #2 Phillips screwdriver to remove the four large screws (Item 1,

Keep the screws. You will replace them at the end of this procedure to mount the bracket on the chassis.

Remove only the screws indicated in

router bottom panel to the chassis.

Figure 2

Remove the Four Large Screws (1) from the Router Base

Place the mounting bracket onto the back of the router, following these guidelines



The bracket handle (Item 3,



Align the bracket mounting holes (Item 2,

Figure 3 on page

39). (The screws were removed from the bracket connectors in Step 2.)

Figure 2 on page

Module Panel

Cable Panel

Figure 3 on page

39) should be facing the router cable panel.

Figure 3 on page

Figure 2 on page

38. Do not remove the smaller screws, which secure the

39) with the router bracket connectors (Item 1,

38) from the chassis base.

(Figure 3 on page

39):

Table of Contents

Chapters

Table of Contents