Table of Contents
Advertisement
Multicast Forwarding
Multicast Forwarding
NOTE
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x
•
Send and receive Multicast packets.
•
Register the Multicast addresses being listened to by the node with local
routers, so that local and remote routers can route the Multicast packet to
the nodes.
Typical Multicast Setup
While Multicast routers route Multicast packets between IP subnets, Multicast-
capable Layer 2 switches forward Multicast packets to registered nodes within a
LAN or VLAN.
A typical setup involves a router that forwards the Multicast streams between
private and/or public IP networks, a device with Internet Group Membership
Protocol (IGMP) snooping capabilities, or Multicast Listener Discovery (MLD)
snooping, and a Multicast client that wants to receive a Multicast stream. In this
setup, the router sends IGMP queries periodically.
MLD for IPv6 is derived from the IGMP v2 for IPv4. Even though the description in
this section is mostly for IGMP, it also describes coverage of MLD where implied.
These queries reach the switch, which in turn floods the queries to the VLAN, and
also learns the port where there is a Multicast router (Mrouter). When a host
receives the IGMP query message, it responds with an IGMP Join message saying
that the host wants to receive a specific Multicast stream and optionally from a
specific source. The switch with the IGMP snooping analyzes the Join messages,
and learns that the Multicast stream the host has requested must be forwarded to
this specific port. It then forwards the IGMP Join to the Mrouter only. Similarly, when
the Mrouter receives an IGMP Join message, it learns the interface from which it
received the Join messages that wants to receive a specific Multicast stream. The
Mrouter forwards the requested Multicast stream to the interface.
In a Layer 2 Multicast service, a Layer 2 switch receives a single frame addressed
to a specific Multicast address. It creates copies of the frame to be transmitted on
each relevant port.
When the switch is IGMP/MLD-snooping-enabled and receives a frame for a
Multicast stream, it forwards the Multicast frame to all the ports that have
registered to receive the Multicast stream using IGMP Join messages.
The switch can forward Multicast streams only based on Multicast MAC Group
Address. It can be configured per VLAN.
The switch maintains lists of Multicast groups for each VLAN, and this manages
the Multicast information that each port should receive. The Multicast groups and
their receiving ports can be configured statically or learned dynamically using
IGMP or Multicast Listener Discovery (MLD) protocols snooping.
14
165
Hide quick links:
Advertisement
Table of Contents
