Cli Command Modes - Cisco Catalyst 3750 Metro Command Reference Manual

Hide thumbs Also See for Catalyst 3750 Metro:

Table of Contents

Using the Command-Line Interface

The Catalyst 3750 Metro switch is supported by Cisco IOS software. This chapter describes how to use

the switch command-line interface (CLI) to configure software features.

For a complete description of the commands that support these features, see

Metro Switch Cisco IOS Commands."

"Catalyst 3750 Metro Switch Boot Loader Commands."

Appendix B, "Catalyst 3750 Metro Switch Debug Commands."

commands, see

information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command Summary.

For task-oriented configuration steps, see the software configuration guide for this release.

CLI Command Modes

This section describes the CLI command mode structure. Command modes support specific Cisco IOS

commands. For example, the interface interface-id command only works when entered in global

configuration mode.

These are the main command modes for the switch:

and how to exit that mode. The prompts listed use the default name Switch.

Appendix C, "Catalyst 3750 Metro Switch Show Platform Commands."

Privileged EXEC

Global configuration

Interface configuration

VLAN configuration

Line configuration

lists the main command modes, how to access each mode, the prompt you see in that mode,

C H A P T E R

For information on the boot loader commands, see

For information on the debug commands, see

For information on the show platform

Catalyst 3750 Metro Switch Command Reference

Chapter 2, "Catalyst 3750