Table of Contents
Advertisement
Adjustment
[Standard]
• When the feed dog is its highest position, the feed dog height from the surface of the
needle plate should be 1 ±0.1 mm (0.9 to 1.1 mm).
• When the feed dog is its lowest position, the feed dog is 0.3 mm or more lower than the
surface of the needle plate.
[Adjustment]
1. Remove the presser foot and the presser foot holder.
2. When the needle plate assy is removed, attach the needle plate assy.
3. Turn the pulley by hand and move the feed dog to its highest position.
4. Insert the hex wrench into the hole of the needle plate, and adjust the feed dog height from the surface of the
needle plate by turning the vertical adjuster screw.
*Key point
• Loosen the vertical adjuster screw. (turn to the direction of "a".) The feed dog is lowered.
• Tighten the vertical adjuster screw. (turn to the direction of "b".) The feed dog is raised.
Needle plate
surface
Needle plate
surface
Feed dog height
Feed dog highest position
1 ±0.1 mm (0.9 - 1.1 mm)
Feed dog lowest position
0.3 mm or greater
3 - 18
b
a
b
a
Vertical adjuster screw
Needle plate assy
A (10 : 1)
A
1.5 mm
17.2 mm
20.2 mm
Hex wrench
2 mm
Feed dog
Hole
Feed dog
1.5 mm
height gauge
Hide quick links:
Advertisement
Table of Contents
