Table of Contents
Advertisement
Adjustment
[Standard]
The left needle drop position at the maximum width zigzag stitch of pattern selecting dial
and the needle drop position at the left needle position straight stitch of pattern selecting
dial should be matched.
[Adjustment]
1. Turn off the power, and then remove the foot controller.
2. Remove the face plate assy, the pattern selecting dial and the feed dial, and remove the
front cover assy and the rear cover assy.
3. Attach the size 90/14 needle.
4. Attach the pattern selecting dial.
5. Turn the pattern selecting dial until the left needle position straight stitch is the topmost position.
6. Turn the pulley by hand and move the needle bar to its leftmost position.
Pulley
7. Lay a paper on the needle plate, and lower the presser foot lifter to lower the presser foot. And make a pinhole
with needle point by turning the pulley by hand from the rear to the front, and then turn the pulley in the
reverse to raise the needle bar.
*Key point
• Keep a paper from moving by hand, after making a pinhole to the paper.
<To next page>
Left straight stitch needle drop and
zigzag stitch maximum left needle drop position
Pattern selecting dial
3 - 15
Needle
Presser foot
Pinhole
Paper
Needle bar
Hide quick links:
Advertisement
Table of Contents
