Table of Contents
Advertisement
Adjustment
[Standard]
• At the left needle position straight stitch of pattern selecting dial and [4] of stitch length
dial, the minimum clearance between the front of the feed dog and the needle plate should
be 1.6 to 2.1 mm.
• The left and right clearance between the feed dog and the needle plate should be the same.
[Adjustment]
1. Remove the presser foot and the presser foot holder.
2. Turn the pattern selecting dial until the left needle position straight stitch of pattern
selecting dial and [4] of stitch length dial are is the topmost position.
3. Turn the pulley by hand and move the feed dog to the front position.
4. Remove the two screws of the needle plate assy, and remove the needle plate assy.
5. Loosen the two screws of the feed dog. Set the needle plate assy temporarily, and adjust the position of the
feed dog.
6. Tighten the two screws of the feed dog to secure the feed dog to the feed stand assy.
7. Tighten the two screws of the needle plate assy to secure the needle plate assy to the feed module.
Feed dog
Feed dog position (front/back and left/right)
Pulley
4
Pattern selecting dial
3 - 17
Screws
Parallel
1.6 - 2.1 mm
a b
a = b
Screws
with hex wrench 2.5 mm
Feed dog
Needle plate assy
Screw needle plate
Needle plate assy
Bolt, Socket M3X5
Hide quick links:
Advertisement
Table of Contents
