Table of Contents
Advertisement
Required Tools and Accessories
The procedure differs depending on the type of table that you have in your room; follow the procedure
Note
for your table type.
Step 5
Set up the speakers by completing the procedure in the
Set up the microphones by completing the procedure in the
Step 6
page
Step 7
Set up the lights devices by completing the procedure(s) in the
section on page
Required Tools and Accessories
The following tools are required to set up the CTS 1100 for the first time:
•
•
•
•
•
•
•
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
4-2
4-28.
4-29.
3mm round head Allen wrench (for aligning the camera rotation)
2.5 mm Allen wrench (used for adjusting the position of the camera)
2.5 mm Allen wrench with a minimum 6 inch (15 cm) extension (for adjusting the camera bracket)
Small spirit level (included with camera kit)
Tape for marking areas on the table—Cisco recommends a tape that does not mar the table or leave
a sticky residue, such as masking tape
Utility knife
Tape measure or paper ruler included with the CTS 1100 accessory kit
Chapter 4
"Setting Up the Speakers" section on page
"Setting Up the Microphone" section on
"Verifying Proper Function of the Lights"
First-Time Setup
4-27.
OL-19695-01
Hide quick links:
Advertisement
Table of Contents
